Sundance-spas Maxxus Manual de usuario descargar pdf (Pagina 18)

Page 15

6. SET HOT TUB TO HEAT (Default Set Temp is 100˚F (38˚C)

To warm the hot tub water up to a comfortable temperature, follow these steps:

• The LED display on the control panel displays the actual temperature of

the hot tub water. Press either the COOLER(Down) or WARMER (Up)

button to display the “set” temperature for 5 seconds. If you want the

water to heat to a different temperature, simply press COOLER or

WARMER within 5 seconds while the “set” temperature is displayed.

The set temperature advances or decreases by one degree each time

one of these sensor pads is pressed.

• The heater will turn off when the temperature corresponding to the ther-

mostat setting is achieved.

NOTE:

•

The maximum temperature for which the hot tub can be set is 104˚F (40˚C) and

the minimum is 65˚F (18˚C).

•Setting the thermostat at maximum will not accelerate the heating process.

This will only result in a higher ultimate temperature.

• If hot tub is hooked up to a15 amp/120V (Bali) Turn off high speed pump to

operate heater.

7. PLACE COVER ON HOT TUB

• Keeping the insulating cover in place anytime the hot tub is not in use

will reduce the time required for heating, thereby minimizing operating

costs.

• The time required for initial heat-up will vary depending on the starting

water temperature and the capacity of your hot tub. Smaller hot tubs

heat at a rate of approximately 6 to 8 degrees per hour; larger hot tubs

heat at about 4 to 6 degrees per hour. The heating rate of a Bali

connected to 120VAC will be about 2 or 3 degrees per hour.

DANGER. RISK OF INJURY. Always check water temperature carefully

before entering hot tub.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

Sin comentarios

Sundance-spas Maxxus Manual de usuario Pagina 18